Standard: 3"-2" Taper & 1.5Lb Foam - $275

Deluxe: 4"-2" Taper & 1.5Lb Foam - $325

 

Information we need from you:

• Measurements (length/width)

• Hinge

• Taper

• Foam Density

• Radius of Corner

• Skirt Length

    When getting the measurements for your spa cover, you should measure from lip to lip, or the outside dimension of the acrylic which is the same as lip to lip. After you have a lip to lip measurement add 1/2" to both the length and the width. This will give you a 1/4" of play all around your spa cover. Be sure to specify where the the cover folds in half if your cover is not square, this is the hinge.
    The taper is the thickness of foam you want, our covers come in two different tapers, 3"-2" and 4"-2" being thickest in the center of the cover and tapering down to 2" on the edge to increase water run-off. When choosing the foam density you have the choice of either 1.5lb or 2lb foam. For information on measuring the radius of your corners click here or you can simply trace your corner and bring it into the shop, we can measure it for you. The skirt length is the skirt that hangs below the foam.